Shop components

SX1278 LoRa Module Ra- 02 433MHZ Wireless Spread Spectrum Transmission for electronics and embedded projects.

Mains-powered switching adapter providing a regulated 12V DC output for compatible electronics.

Hook up Wire (black) - 5 meters for electronics, IoT, and prototyping projects.

ST-LINK V2/V2.1 USB-C Programmer and Debugger for STM32 Microcontrollers - 7Semi for electronics and embedded projects.

40-pin single-row female header strip for mating with 2.54mm male headers on PCBs and modules.

Single-touch capacitive sensor module with digital output for touch-sensitive controls.

V6 Volcano Brass Length Extruder Nozzle 1.75mm x 0.8mm is a replacement or upgrade component for compatible 3D printers and extrusion sys...

SD Card Module for electronics, IoT, and prototyping projects.

7Semi SHT20 Humidity Temperature Sensor Breakout Module Qwiic.

300 RPM Dual Shaft BO Motor-Straight for electronics and embedded projects.

SmartElex IIC/I2C Serial Interface Adapter Module – LCD Display Interface Converter Board for electronics, IoT, and prototyping projects.

65mm rubber-tread wheel designed to fit common BO motors for small robot vehicles.

LiPo Battery Voltage Tester. Designed for electronics, embedded and IoT projects.

Reusable 20cm male-to-male Dupont wires for solderless prototyping and breadboard connections.

7Semi SHT45 Humidity & Temperature Sensor Breakout Board with 4-Pin Connector.

10K Thermistor Temperature Sensor Module(4 Pin).

Compact 128x64 blue OLED module with a four-pin I2C connection.

7Semi STM32C011J6M6 Micro Development Board provides a compact platform for embedded development, prototyping and connected electronics.

7Semi AP3012 DC-DC Boost Converter Module 24V Output for electronics and embedded projects.

10KΩ variable resistor with knob for manual adjustment of analog voltage or signal level.

Low-cost digital thermostat controller with display, probe, relay output, and adjustable temperature setpoints.

BC557 PNP Transistor - (Pack of 5) for electronics, IoT, and prototyping projects.

Endstop Switch for 3D Printers with Cable is a replacement or upgrade component for compatible 3D printers and extrusion systems.

ACEBOTT 130 DC Motor Module for Arduino, ESP32 & Raspberry Pi for electronics and embedded projects.