Shop components

Pure Copper 1000mm Length Cable with Dupont Connector for NEMA17 Stepper Motor for electronics, IoT, and prototyping projects.

Soldering Paste (15g) for electronics, IoT, and prototyping projects.

INA219 I2C Voltage, Current, Power Monitor Sensor Breakout Board -7Semi.

Two-channel 5V relay interface for switching higher-voltage or higher-current loads from logic signals.

Transparent Hot Melt Glue Stick for Glue Gun - 1 Piece for electronics, IoT, and prototyping projects.

DS3231 Real Time Clock Module for Raspberry Pi (Without Battery) for electronics, IoT, and prototyping projects.

Arduino UNO R3 Transparent Plastic Case for electronics, IoT, and prototyping projects.

General-purpose NPN bipolar transistor pack for switching and low-power amplification in through-hole circuits.

4-pin Long PushButton Switch (Pack of 5) for electronics, IoT, and prototyping projects.

Matek Systems PDB-XT60 Power Distribution Board for electronics, IoT, and prototyping projects.

Non-polarized 100nF ceramic capacitors for high-frequency bypass and local IC decoupling.

Tilt Sensor Module for electronics and embedded projects.

7Semi MCP4728 Quad DAC Module for electronics, IoT, and prototyping projects.

Adjustable infrared reflective proximity sensor for short-range object detection and obstacle sensing.

IR Receiving Head VS1838B Remote Control Receiver.

12V 2A SMPS. Designed for electronics, embedded and IoT projects.

HT12D Decoder IC for electronics, IoT, and prototyping projects.

Raspberry Pi 4 Model B 2GB RAM Single Board Computer for electronics, IoT, and prototyping projects.

ADS1115 4-Channel 16bit ADC Breakout Board with PGA I2C -7Semi for electronics, IoT, and prototyping projects.

USB Type-C charger board for a single 3.7V nominal Li-Ion or Li-Po cell with protection.

Witty Fox 3.7V 2000 mAh Li-ion GPS Cylindrical Battery for electronics, IoT, and prototyping projects.

V6 Volcano Brass Length Extruder Nozzle 1.75mm x 0.6mm is a replacement or upgrade component for compatible 3D printers and extrusion sys...

USB-to-UART TTL converter module based on CP2102 for serial programming and debugging of embedded boards.

AMS1117 3.3V Power Supply Module. Designed for electronics, embedded and IoT projects.