Shop components

ESP32 LoRa with 0.96 Inch Blue OLED Display ( Type C- Connector) for electronics and embedded projects.

Low-cost digital sensor for basic temperature and relative-humidity monitoring.

Screw-terminal male DC barrel plug adapter for 5.5mm/2.1mm low-voltage power connections.

Reusable 20cm male-to-female Dupont wires for connecting headers, modules and breadboards.

AC230V 25W Soldering Iron for electronics, IoT, and prototyping projects.

Alligator clip with Cord Pack of 5 for electronics, IoT, and prototyping projects.

60 RPM L Shaped Single Shaft BO Motor (2 pcs) for electronics and embedded projects.

HT12D Decoder IC for electronics, IoT, and prototyping projects.

Compact lever-actuated microswitch for end-stop, position detection, and simple mechanical interlock circuits.

6 AA Battery Holder. Designed for electronics, embedded and IoT projects.

2A Step-up MT3608 2V-24V DC-DC Boost Converter Module with Micro USB Port. Designed for electronics, embedded and IoT projects.

Simple resistive soil-moisture module with analog and threshold-based digital outputs.

Pack of ten 220Ω carbon-film resistors for current limiting and general-purpose prototyping.

1.75mm Premium HS PLA Filament for 3D Printer (Blue) for electronics, IoT, and prototyping projects.

100 Ohm Resistor - (Pack of 10) for electronics, IoT, and prototyping projects.

3.7v 2000mah li-ion single cell prismatic battery (yellow) for electronics, IoT, and prototyping projects.

7Semi 64MHz ARM Cortex-M0+ STM32G0B0KET6 Development Board provides a compact platform for embedded development, prototyping and connecte...

7Semi AP3012 DC-DC Boost Converter Module 24V Output for electronics and embedded projects.

Key Display For AVR Arduino New 8-Bit Digital LED Tube 8-Bit TM1638 Module for electronics, IoT, and prototyping projects.

PWM DC Motor Speed Controller. Designed for electronics, embedded and IoT projects.

XL7015 Wide Range DC-DC Voltage Converter. Designed for electronics, embedded and IoT projects.

Pure Copper 1000mm Length Cable with Dupont Connector for NEMA17 Stepper Motor for electronics, IoT, and prototyping projects.

Lightweight two-axis plastic pan-tilt mount for positioning small cameras or sensors with hobby servos.

Laser Module for electronics and embedded projects.